Date:  Sun, 1 Apr 2007 13:15:23 +0300
From:  "Biju" <biju (at mark) simbanet.co.tz>
Subject:  [coba-e:09408] Re: AW:  Re: Dovecot problem after update
To:  <coba-e (at mark) bluequartz.org>
Message-Id:  <200704011333125.SM00632@Virus>
In-Reply-To:  <003901c77272$810539b0$1e64a8c0 (at mark) nuonce.net>
X-Mail-Count: 09408

Hi Brian,

Thanks a lot.

I am getting the utilisation as given below

cpu(s): 11.1% us, 88.9% sy,  0.0% ni,  0.0% id,  0.0% wa,  0.0% hi,  0.0% si

And in the server monitor it says CPU utilised heavily

Is this normal? 


Thanks & Regards,
 
Biju.V.P
SimbaNET(T)Ltd.,
Tancot House,Sokoine Drive
Dar-Es-Salaam,Tanzania.
Phone: 255 22 2112000 ext.228

-----Original Message-----
From: Brian N. Smith [mailto:brian (at mark) nuonce.net] 
Sent: Friday, March 30, 2007 5:24 AM
To: coba-e (at mark) bluequartz.org
Subject: [coba-e:09376] Re: AW: Re: Dovecot problem after update

> Jason Humphrey <mailto:jasonh (at mark) businessws.com> schrieb am Donnerstag, 
> 29.
> MçÓz 2007 12:11:
>> I haven't had any problems with the new conf file, all the changes 
>> you mentioned are already there.
>
> you are probably not using it. dovecot.conf.rpmnew is the standard 
> config file that came with the update; but yum didn't overwrite your 
> old one.

Just to clear it up.  It wasn't supposed to be over written.  The existing
configuration was fine the way it was.  I did release a new version RC28,
which DOES over write the old configuration, along with configure it
properly to avoid any issues.

Thanks!
Brian 


--
This message has been scanned for viruses and dangerous content by
MailScanner, and is believed to be clean.



-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.