Gerald Waugh wrote;
> Gerald Waugh wrote;
>> Gerald Waugh wrote
>>
>>> Acts like maybe a shared IRQ problem
>>> Install goes to a point where it reads
>>> ide assuming 33MHz bus speeds for PIO modes; override with idebus=xx
>>>
>>> This same server loads BlueOnyx with no problems.
>>> Not sure what is going on,
>>> Although it seems like it stalls sometimes when initalizing the Serial
>>> port
>>>
>>> Any ideas????
>>>
>> Crazy,
>> above error was with the Lilo loader which is what I usually use for
>> CentOS+BlueQuartz.
>> I tried again using the Grub loader and it worked.
>>
> False alarm, it loaded but had both drives as one LVM
> So hitting F3 and then enter 32 (RAID Mirrot)
> gives error as above
> ide: assuming 33MHz bus speeds for PIO modes; override with idebus=xx
>
> works with one drive but not using RAID
Excuse me, talking to myself!
I reloaded BlueOnyx, and it loads OK
has /etc/raidtab and /proc/mdstat shows they are mirroring.
But can't load BlueQuartz in a RAID configuration
Gerald