Date:  Fri, 4 Sep 2009 19:38:42 -0500
From:  "Gerald Waugh" <gwaugh (at mark) frontstreetnetworks.com>
Subject:  [coba-e:15993] Re: Nuonce 4.8 install problem
To:  <coba-e (at mark) bluequartz.org>
Message-Id:  <CAA392DA5C534F989620BF25CACE5F6D@raqware>
References:  <3069CDDA475D47B5A1FB3F07907E55FC@raqware> <C6DF5B91A30C416C810249BE49690E7F@raqware>
X-Mail-Count: 15993

Gerald Waugh wrote;
> Gerald Waugh wrote
> 
>> Acts like maybe a shared IRQ problem
>> Install goes to a point where it reads
>> ide assuming 33MHz bus speeds for PIO modes; override with idebus=xx
>>
>> This same server loads BlueOnyx with no problems.
>> Not sure what is going on,
>> Although it seems like it stalls sometimes when initalizing the Serial 
>> port
>>
>> Any ideas????
>>
> Crazy,
> above error was with the Lilo loader which is what I usually use for 
> CentOS+BlueQuartz.
> I tried again using the Grub loader and it worked.
> 
False alarm, it loaded but had both drives as one LVM
So hitting F3 and then enter 32 (RAID Mirrot)
gives error as above
ide: assuming 33MHz bus speeds for PIO modes; override with idebus=xx

works with one drive but not using RAID