Date:  Sun, 9 Dec 2007 10:51:09 -0600
From:  "Gerald Waugh" <gwaugh (at mark) frontstreetnetworks.com>
Subject:  [coba-e:11382] Re: Tyan GT14 CBQ Inatall from Tyan
To:  <coba-e (at mark) bluequartz.org>
Message-Id:  <000001c83a83$b72e97f0$0101a8c0@systemax>
In-Reply-To:  <00cb01c839c7$d2002880$0101a8c0@systemax>
X-Mail-Count: 11382

At last, the Tyan GT20 is working.

Disable ACPI in the BIOS "power options"
If dual drive install, use the SATA1 and SATA2 connectors
If single drive install, use SATA1 connector
  these are the 2 inboard connectors
  SATA1 connector is the one towards the back of the server
  Viewed from the front of server

  SATA4     SATA1  
  =====     =====
  SATA3     SATA2
  =====     =====

  The install will recognize these as SATA1 hda and SATA2 hdc
At the boot prompt
  (use IDE install options)
    add "all-generic-ide" (no "") after the install option
  i.e. " 22 all-generic-ide "

The install should proceed normally.
When the system reboots, the drives will be "sda" and "sdb" 
And the system will be running in SATA2 mode.




-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.